Tankless Water Heater Installation in Murfreesboro

Is a Tankless Heater Right for Your Home?

Instead of keeping a 40- or 50-gallon tank hot around the clock, a tankless heater fires up the moment someone turns on a hot faucet and shuts off when they're done. Nobody gets stuck with a cold rinse on the third shower of the morning. The unit mounts on a wall, so you get back floor space in the garage or utility closet.

It isn't the right fit for every home, and we'll be honest if yours isn't one. Moving off a tank often calls for a bigger gas line, new stainless or PVC venting, a dedicated electrical circuit, or some mix of those. Those costs are real, so each one goes into your written quote with a plain reason it's needed. If a new tank heater suits your budget better, we'll tell you.

What Your Installation Includes

Sizing by flow, not guesswork

We count the fixtures you might run at once and figure the gallons per minute you need. Incoming water in Middle Tennessee runs colder in winter, so we size for January, not July.

Removal of the old tank

We drain and disconnect your existing water heater and haul it away. You won't be left with a rusty tank in the driveway.

Gas, venting and electrical

Gas units usually need a bigger supply line and dedicated venting run to the outside. Electric units may need a heavy-duty circuit. We check your existing setup and price any upgrade in writing before we touch it.

Maintenance valves on the hookup

We fit shutoff and flush ports on the hot and cold lines at the heater. When it's time to clear scale, a hose connects right there, so yearly upkeep stays quick and inexpensive.

Code-compliant work

We hold a Tennessee CMC-A plumbing license and install to code, with proper clearances, pressure relief and gas connections. Since we're also backflow certified, we check any backflow or check valve on your water supply while we make the hookup.

A walkthrough before we leave

We fire the unit, test hot water at your fixtures, and show you how to read the display and where the shutoffs are.

Signs It's Time to Look at Tankless

• You keep running out of hot water

  If back-to-back showers turn cold, your tank can't keep up with your household. A properly sized tankless unit keeps going as long as you need.

• Your tank heater is 10 years or older

  Most tank heaters wear out somewhere past the decade mark. Planning a switch now beats replacing it in a hurry after it fails.

• Rusty water or a puddle under the tank

  Rust-colored hot water or water pooling at the base usually means the tank lining is failing. That tank is near the end and can let go without much warning.

• You need the floor space

  Finishing a basement or reworking a garage goes easier when a bulky tank isn't in the way. A wall-mounted unit takes up a fraction of the room.

• Rumbling or popping from the tank

  Those sounds come from sediment baked onto the bottom of the tank. It means the heater is working harder and wasting energy every cycle.

How the Job Goes

1. 1

   Free in-home estimate

   We look at your current heater, gas meter, venting route and electrical panel. Then we talk through how many people live in your home and how you use hot water.

2. 2

   Your written quote

   You get the unit model, every upgrade and the total price in writing. Nothing gets added later without your sign-off.

3. 3

   Install day

   First we cover the floors along our path and close off your water and gas supply. The old heater comes out, and the new unit goes up on the wall with its piping and vent. A straight swap usually fills one day, with extra time if we're running a new gas line or vent.

4. 4

   Testing and cleanup

   We check every gas fitting for leaks, test water temperature at the far faucets, clean up our work area and haul off the old equipment.

What Moves the Price

Two homes on the same street can have very different tankless costs. The unit itself is only part of it. What's already in your home decides how much extra work the switch takes, and we lay all of it out on paper before work begins.

Unit size and fuel type

Larger homes with more bathrooms need higher-capacity units. Gas and electric models also differ in price and in what your home needs to run them.

Gas line capacity

Tankless gas units draw far more fuel at once than a tank. If your current line is too small, it has to be upsized from the meter.

Venting route

A short run straight through an outside wall costs less than a long run through an attic or up through the roof.

Electrical work

Electric units, and some gas units, need a new dedicated circuit. Panel capacity affects how simple that is.

Water treatment

Hard water builds scale inside the heat exchanger. Some homes benefit from a softener or our whole home water filtration service, which we'll price separately if you want it.